The IC-756PROII/III, IC-746PRO, IC-7400 or IC-7000 can be connected to a PC with an audio cable and RS-232C cable through CT-17 CI-V level converter*. *RS-BA1 operation with the Base station's PC connected to the radio's ACC socket, MIC connector, or S/P DIF jack for audio communication cannot be guaranteed. *Depending on your radio, a few functions or modes cannot be used, or you need to update the radio's firmware to operate the CW keyer, using the RS-BA1.ĭepending on your transceiver, some functions or modes cannot be used, or you need to update the transceiver’s firmware.
Please use the latest firmware version of the transceiver. The optional RC-28 utilizes the same tuning knob and encoder used on Icom HF radios, providing a tactile option for the RS-BA1 software. The encoder includes a PTT and two user-programmable function keys.
Pentium 4 1 GHz or better (A multicore CPU is recommended.) The RC-28 is not a standalone control for Icom radios and may only be used with the RS-BA1 software. The exact capabilities of this device varies by radio model.Ĭopyright 2019-2021, Universal Radio, Inc.(The Voice Memory function or Recording function will need more) This software is designed to operate with Windows® 7, Windows® 8.1 and Windows® 10 on a PC with 1.8 GHz processor or better, 150 Mb HD, 1024x768 resolution.
The IC-7300 can be connected to a PC via a USB cable and the input/output audio signal and CI-V command is sent through the USB cable. Remote control software provides a user interface, similar to the radio's front panel, and allows you to control the radio from a remote location. System configuration software sets up IP address, audio sampling rate and other settings.Ģ. The RS-BA1 Windows® CD consists of two component software applications:ġ. Shown above in use with a dual-receive transceiver. The RS-BA1 Version 2 can also still be used with single-receiver transceivers.
The RS-BA1 Version 2 can also enlarge the panel size (normal or large is selectable), buttons added, clickable indicators to change settings, SUB dial added and RIT tuning knob & TX functions added. With the RS-BA1 Version 2, you can use the dual watch operation and spectrum scopes with waterfall function as well as observe the MAIN and SUB spectrum scopes. The S-Meter and SWR can even be observed. Low voice latency (caused by the RS-BA1) provides the same operational experience as using an actual radio. Most functions and modes of your Icom compatible transceiver can be controlled, including interference rejection functions and IF filter settings. The Icom RS-BA1 v2 IP Remote Control Software allows you to use an Icom compatible radio installed in another room using your home network or even from a remote location over the Internet.
0 kommentar(er)
